Fe/Steel Endless Adhesive Wheel Balance Weights F110

• Standard: Standard
• Condition: New
• Material: Fe
• Origin: Zhengjiang, Ningbo

• Type: Wheels Localizer
• Certification: ISO
• Description: Steel Adhesive Balance Weights
• Port: Ningbo
• Specification: 50pcs/box, etc. Customized

Height:3.0mm(include tape 4.0mm)

Width:19mm

Total weight:5kg/6kg

Packing: 5kg/roll,1roll/box,4boxes/ctn OR 6kg/roll,1roll/box, 3box/ctn, AND customized is also welcomed

Steel endless adhesive weight with 1000pcs znic plated and coated segment of 5grams each on a roll. It's made up of 1000x5 grams segments. 1200x5 grams segments is also available.

Surface: Zinc plated and Epoxy coated is avaliable.

Installation of Adhesive Weights:

Pre-treating the rim:

Clean the rim thoroughly with a cleaning agent that is compatible with varnish(e.g. IPA 70%) in order to remove any residual grease, silicone or adhesive.

Please note: A minimum of 15ºC is required in terms of both the room temperature and the rim temperature.

Pre-bending the weights:

Separate the correct gram(as calculated) from the bar. Mould the shape of the weight to match the rim radius(with protective film).

Please note: You need to bend the weights gradually, otherwise they will break apart at the joins. You should bend the weight to a little more than the rim's radius.

Removal of the protective film:

Remove the protective film.

Please note: Do not touch the glued surface after peeling off the rim.

Sticking the weight on:

Attached the weight to the calculated point on the rim, making sure that the weight is distributed evenly either side and the weight is parallel with the edge of the rim.

Please note: Press down on the weight hard, working from the centre to the left and right. A minimum pressure of 1kg/cm2 is required. The angle of the sticking surface should not be higher than 15 ºC to normal.